Edit DNA RBF Solver

When to use it

Adds or removes whole RBF solvers on a DNA, as an ordered list of operations applied atomically - drivers, the wire-format settings and LOD membership for Add; a poses policy (remove/keep) plus an optional force cascade for Remove. Editing an existing solver's own 12 fields stays on Set DNA RBF Pose; this node only adds whole solvers or removes them.

How to use it

1. 1

   Wire a DNA in

2. 2

   Build an ordered list of operations in the Operations panel below the properties

   Each entry picks Add / Remove. Add needs a New Name, a Driver Controls table (raw controls, in order - the panel shows a live quartet badge next to it) and the solver settings; Remove needs a Solver picker (pads are hidden - they are never a valid target) plus Keep Poses / Force Cascade. Untick an entry to keep it staged without running it.

3. 3

   Press Apply RBF Solver

   Every enabled entry runs in order against the result of every earlier one - adding a solver then removing it again in the very next entry works. The whole batch is atomic: the first refusal publishes nothing at all, not even the operations before it.

Pins

Settings

Learn more